STRUCTURAL PERFORMANCE SIMULATION Structural analysis review checklist 1. PURPOSE AND SCOPE [ ] Define the physical question and the response quantities of interest. [ ] Identify the loading scenario and expected governing mechanisms. [ ] State relevant assumptions and the intended range of application. 2. MODEL AND INPUTS [ ] Record the consistent base units for force, length and time. [ ] Check geometry, connectivity, supports, constraints and releases. [ ] Document material laws, parameter sources and calibrated values. [ ] Describe interfaces, contact, bond, slip and separation assumptions. [ ] Record load histories, control variables and initial conditions. [ ] For dynamic analysis, check mass, damping and excitation units. 3. NUMERICAL VERIFICATION [ ] Check a simple elastic solution or an appropriate benchmark. [ ] Review reactions, force equilibrium and unintended mechanisms. [ ] Examine mesh, increment and time-step sensitivity as applicable. [ ] Review convergence criteria, solver warnings and failed increments. [ ] Inspect relevant energy terms when using a dynamic procedure. [ ] Check loading-rate and mass-scaling effects for quasi-static explicit work. 4. COMPARISON WITH EVIDENCE [ ] Match loading and boundary conditions in the comparison. [ ] Compare relevant curves and deformation or damage patterns. [ ] Distinguish the data used for calibration from independent validation. [ ] Report discrepancies and the response range supported by evidence. 5. INTERPRETATION AND REPORTING [ ] Explain the governing mechanism rather than only presenting contours. [ ] Define derived response measures and processing steps. [ ] Report parameter sensitivity and consequential uncertainty. [ ] Retain input versions, settings, records and selected outputs. Further reading is linked on the website's Notes & Resources page.